Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fourhexagons

Pages: [1]
1
preenfm2 and preenfm3 / Re: Saving preset into empty Bank/Combo slot
« on: July 11, 2017, 06:35:10 PM »
 :D
Cheers ~

2
preenfm2 and preenfm3 / Re: Saving preset into empty Bank/Combo slot
« on: March 30, 2017, 03:45:51 AM »
Thanks, guys. It's funny, I had notifications disabled, so I hadn't seen your replies until now as I'm logging on to say that I figured it out. I even went through the same steps, first checking the USB stick, reformatting, trying a second stick, and then I played with the menus a bit more and finally discovered that you must first create a Bank/Combo in Tools > Crea *before* you can save into it. I hadn't expected that extra step, but I'm glad to be up and running now.

Xavier, adding a line like the following at the beginning of 2. Save in the manual might help other newcomers like myself:

Presets can be saved only into preexisting Banks or Combos. To save a preset in an empty slot, you must first create a Bank or Combo in that slot by going to Tools > Crea. Once you have created a Bank or Combo slot, you will find it under Menu > Save.

3
preenfm2 and preenfm3 / Saving preset into empty Bank/Combo slot
« on: March 29, 2017, 01:47:12 AM »
Hello,

I just received a pre-built PreenFM2 from Ardi at Van Daal (thanks). It's running firmware v2.06. I edited the preset that was presented at startup and now I want to save it to an empty bank.

This is what I'm doing:

Menu > Save > Bank > select empty bank slot > press MENU

...but nothing happens.

Menu > Save > Combo > select empty combo slot > press MENU

...still nothing.

What am I missing?

Thanks,
Bryan

4
preenfm2 and preenfm3 / Re: New firmware 2.07 (December 16th 2016)
« on: March 29, 2017, 01:32:51 AM »
Heads up: the link to firmware 2.07 (in the first post) is broken.

Pages: [1]