1
preenfm2 and preenfm3 / Re: Yellow OLED : high frequency solution
« on: November 27, 2017, 07:08:11 PM »
I'm assuming the power connector ground would be a good place?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
preenfm2 and preenfm3 / Re: Yellow OLED : high frequency solution
« on: November 27, 2017, 01:06:12 PM »
I made a shield as described, which seems to be working (at least I'm not aware of any noise). I was then sent a shield by Ardi at Vandaal, as it (and a volume knob) had been missing from the kit when it was posted out.
I notice Ardi's shield has a wire soldered to it and I assume that the other end needs to go to Ground or 0V. Any suggestions about the best place to solder this shield to?
Godric
I notice Ardi's shield has a wire soldered to it and I assume that the other end needs to go to Ground or 0V. Any suggestions about the best place to solder this shield to?
Godric
Pages: [1]