Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - monohusche

Pages: [1]
1
PreenFM1 (the blue one) / Re: Last minute issue
« on: January 26, 2012, 03:25:55 PM »
just checked out the firmware section (ooops, have to open the case again :-). but realised, that this seems to be working only for windows ? Is there a way to apply the firmware using OSX ?

Nick

2
PreenFM1 (the blue one) / Re: Last minute issue
« on: January 26, 2012, 03:20:51 PM »
alright, I think, I found one dead connection, but maybe, I didn't adjust the contrast correctly.

now everything is fine, and I can check it out :-)

thx nick

3
PreenFM1 (the blue one) / Re: Last minute issue
« on: January 26, 2012, 01:34:01 PM »
Hi Xavier,

yes, just checked, heard the boot sound, will check the connections now that you indicated

thx a lot,  nick

4
PreenFM1 (the blue one) / Last minute issue
« on: January 26, 2012, 12:59:57 AM »
Hi there,

started yesterday to build my PreenFM, and everything went smooth until the time the blue top plate was assembled and I connected it to the laptop for the first time. Menu showed ("algo xx"), I could move the encoders, adjust the brightness etc. I then assembled the housing, put the knobs on (quite some pressure required and finished everything.

Unfortunately, now something seems to be broken. If I connect, the LCD kind of backlits (light at top and bottom of the lcd), but there is no text, and the contrast can't be changed either. The light in the middle of the Maple Mini does blink though 5-6 times.

Any idea where to check first ? I am dreading to take the knobs off again and check every connection.

Thx a lot, Nick

Pages: [1]