Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - randy

Pages: 1 2 [3]
31
PreenFM1 (the blue one) / Tonight's the night
« on: September 11, 2012, 04:02:22 PM »
Finished building my PreenFM last night (Sept 10th) and hoping to test it tonight.  It really is an easy build, although perhaps I shouldn't mention that until after I see if it works!

A little while ago there was a thread on the Mutable Instruments forum discussing first builds for someone who is new at DIY electronics.  The idea was to find something not too expensive, easy to build and useful.  The Shruthi, while not overly difficult, is a bit much for a first build.  I think, with some adjustments to the online build instructions, the PreenFM could be done by a newcomer.

Hopefully I can report back later today.

Randy

32
PreenFM1 (the blue one) / Re: Back in stock!
« on: August 27, 2012, 09:20:43 PM »
Xavier, you should do a Preen voice card for the Ambika!  Probably easier to say than to do I'm sure.

Randy

33
PreenFM1 (the blue one) / Back in stock!
« on: August 27, 2012, 06:51:24 PM »
I just ordered my first PreenFM!  Went for the new "Crystal" version, looking forward to building and hearing this.  Should go well with my two (so far) Shruthis.  Ambika is next.

Randy

34
PreenFM1 (the blue one) / Re: Firmware 2.0 wish list....
« on: August 02, 2012, 08:11:35 PM »
Xavier, I'm the guy who started the thread on the Mutable Instruments forum.  I was looking for some feedback on the PreenFM and it seems everyone over there is quite impressed with it.

Olivier is most certainly a special guy, very impressive and it is great that he was able to help you out.  I'm really looking forward to ordering a PreenFM when they are back in stock.

Randy

35
PreenFM1 (the blue one) / Re: Using the Preen a LOT in a new project
« on: August 02, 2012, 08:08:43 PM »
First post just to comment on this.  I was planning on buying a PreenFM but notice they are out of stock, figured I'd register early because that case is so cool!  Hope you don't mind if I copy a few of your case ideas.

Randy

Pages: 1 2 [3]