Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - samuelous

Pages: [1]
1
preenfm2 and preenfm3 / Re: Sawtooth waveform
« on: December 01, 2018, 10:22:40 AM »
You can also try loading your own user waves. I tried using sampled saw waves from analog gear and ended up hating it for FM purposes. I also tried a more “accurate” saw wave and the reuksts were too buzzy and filled with unwanted artifacts.

Would you mind sharing some of those sampled saw waves? Now a few weeks further I see how saw isn't the ideal shape for FM synthesis and I probably won't be using it a lot. But I am curious :)

2
preenfm2 and preenfm3 / Re: Sawtooth waveform
« on: October 31, 2018, 01:48:03 PM »
That makes sense for an FM way, I was more wondering if I could use the custom waveforms to blend a more "regular" saw shape on a carrier with my FM operators to create unique combinations. But perhaps I should first explore FM more and create a saw-ish shape using your suggestion :)


3
preenfm2 and preenfm3 / Sawtooth waveform
« on: October 30, 2018, 04:49:45 PM »
Hi all!

I just got my preenfm2 this week! I am really loving the device, so much good stuff to say.

I am wondering some things about the default saw waveform, it sounds a bit muffled, is this because its a low ramp? Is this a conscious design decision perhaps because a pure saw is less usable in FM synthesis?

I was also wondering if someone here has a a nice pure saw waveform that they would be willing to share here, or if this is perhaps impossible on the pfm2.

Thanks!


Pages: [1]