PreenFM > preenfm2 and preenfm3
Help
Tenchi:
Hi
I've constructed the PreenFM 2 as per instructions. I've got to the step where you press the OP button while switching the unit on and .......
nothing.
The screen is lighting up but thats all.
I feel i've followed the instructions to the letter and now i'm stuck.
Any help would be welcome
Thanks
Xavier:
Hi,
And what do you see if you switch on without pressing "Op" button ? nothing either ?
The cerb40 you reveived with your Kit is ready to use so it should boot normaly without any flashing.
Switch on the PreenFM, without pressing any button.
Have you tried to turn the LCD resistor contrast to the end in both direction while looking at the LCD ?
Have you tried sending midi notes to the Midi IN Jack ? Do you hear any sound on the audio jack ?
Let me know,
If nothing works, next step will be to check the 3.3V points on the PCB.
Xavier
Tenchi:
Hi Xavier
what do you see if you switch on without pressing "Op" button ?
nothing
Have you tried to turn the LCD resistor contrast to the end in both direction while looking at the LCD ?
Yes
Have you tried sending midi notes to the Midi IN Jack ?
Yes
Do you hear any sound on the audio jack ?
No, no sound.
OK where are these 3.3v points?
Thanks
Xavier:
JMP3 is unshorted, right ?
Here are the 3.3V in the attached png:
Check all the soldering point circled in orange.
Xavier
Tenchi:
Hi
The JMP3 was shorted, i removed the jumper and tried again with no luck.
All voltages at the points shown are correct. The LCD dims and brightens when moving the trimmer.
I've re flowed all solder joints and still nothing.
Any further hints?
Thanks
Navigation
[0] Message Index
[#] Next page
Go to full version