Author Topic: 115k resistors  (Read 9507 times)

6581punk

  • Team Member
  • ***
  • Posts: 110
    • View Profile
115k resistors
« on: December 31, 2013, 12:33:12 AM »
I'm building my Preen 2 from just the PCB and I forgot to order the 115k resistors. My local store only does 110k or 120k.

Will either of those values do? the tolerance of 5% means a 115k could be 109.25k or 120.75k anyway.

Xavier

  • Administrator
  • Hero Member
  • *
  • Posts: 2256
    • View Profile
Re: 115k resistors
« Reply #1 on: December 31, 2013, 10:38:35 AM »
You should go for 1% tolerance resistors for the filter : 1.8K, 8.2K, 115K. (220 and 10K are much less value sensitive).
1.8K & 8.2K define with some capacitors the cutoff frequency of the antialiasing filter.. So you don't want it to be too low not to remove high frequencies. It's set at 20Khz.
The 115K adds a 6 bits dac output to the other DAC that comes from the 1.8K, so you want 115K/1.8K to be as close as possible to 64 (2^6). So that your 18 bits DAC is as linear as possible.
120/1.8 = 66.6... Should work.
I would go for 120K. Buy several and select the 2 that are closer to 115K.  ;)

Xavier

6581punk

  • Team Member
  • ***
  • Posts: 110
    • View Profile
Re: 115k resistors
« Reply #2 on: December 31, 2013, 12:48:43 PM »
There was me forgetting the tolerances of the various resistor types :)

I'll just use some 120k for now then, i'll solder them in with long leads so I can pull them out and replace with 115k when they arrive.

Thanks :)
« Last Edit: December 31, 2013, 12:52:10 PM by 6581punk »

6581punk

  • Team Member
  • ***
  • Posts: 110
    • View Profile
Re: 115k resistors
« Reply #3 on: December 31, 2013, 06:05:25 PM »
In the end my DAC chipped arrived and is the surface mount version :( pretty sure it looked like a DIL in the photo. So I can wait for the correct 115k resistors to arrive.

Once you flash the bootloader and firmware is the internal USB cable needed? only the one I made didn't work.

Xavier

  • Administrator
  • Hero Member
  • *
  • Posts: 2256
    • View Profile
Re: 115k resistors
« Reply #4 on: January 01, 2014, 04:30:08 PM »
Once you flash the bootloader and firmware is the internal USB cable needed? only the one I made didn't work.

Other than flashing firmware the Internal USB cable is needed to :
. have Midi over USB working
. seeing and managing your USB Stick from your computer (Bootloader 1.10+ needed)

Xavier

6581punk

  • Team Member
  • ***
  • Posts: 110
    • View Profile
Re: 115k resistors
« Reply #5 on: January 03, 2014, 02:42:40 PM »
Thanks. It's all working now.

There is some high end sounds, these may be just part of the patch (I'm not sure).

I put some 120k in temporarily (I bought 4 and they all measured 119.7k though) and will replace with the precision 115k when they arrive.

I've yet to listen to it through some decent speakers, but there seems to be a lot more precision in the parameters.