PreenFM > preenfm2 and preenfm3
Built!
tIB:
Picked up from the post office this morning, a few hours later and Im done...
Beauty, I knew those old elektron knobs would come in handy on something!
Anyway, I think I have an issue with one of my outputs- from what I can tell only one of them is working. I'll have a proper poke around in a bit but if anyone has any ideas Im all ears- plan is to test again and start by checking the soldering on the output. Also is it normal that the encoder clicks represent two turns? To make a fine change I have to go really slow to avoid skipping on another value.*FIXED*
pld:
--- Quote from: tIB on June 07, 2014, 05:48:50 PM ---Also is it normal that the encoder clicks represent two turns? To make a fine change I have to go really slow to avoid skipping on another value.
--- End quote ---
Is that with the encoders from the kit?
If not, there's a menu setting to switch between 12/24 steps which could help...
tIB:
Yeah they were from the kit- Ill have a look into that setting when testing later, thanks!
tIB:
Both issues sorted- encoder resolution thing solved that problem and found a joint I missed... hurrah indeed!
pld:
Great!
Navigation
[0] Message Index
[#] Next page
Go to full version