PreenFM > preenfm2 and preenfm3

pfm2 with yellow OLED : high frequency solution

<< < (5/11) > >>

sixbyseven:
Sorry, (I am new to this conversation), if these questions don't seem relevant.

1) Does this same signal (around 14Khz) appear when the OLED is in sleep mode (blank).
2) Has anyone tried a different colour OLED (example:Blue) from the same manufacturer?

Thank you,

Todd

Godric:
I made a shield as described, which seems to be working (at least I'm not aware of any noise). I was then sent a shield by Ardi at Vandaal, as it (and a volume knob) had been missing from the kit when it was posted out.

I notice Ardi's shield has a wire soldered to it and I assume that the other end needs to go to Ground or 0V. Any suggestions about the best place to solder this shield to?

Godric

Godric:
I'm assuming the power connector ground would be a good place?

lokki:
yes, that would be ok.

molpho:
Hi! I bought a Preenfm2 from Van Daal. I'm really loving it, but I hear the "OLED noise" and since I don't know anything about soldering and DIY I was wondering if there is a way to delete that freq without affecting the timbre of my patches... may I use an eq? could be enough?

Navigation

[0] Message Index

[#] Next page

[*] Previous page