PreenFM > preenfm2 and preenfm3
Screen issue help!
shwanton:
Thank you for the response.
I'm going to resolder both sides of the OLED pins. Hope that fixes the issue. Will report back.
served:
Have a look at this picture.
Make sure you have a good connection for thouse 6 pins. I would suggest you to solder 6 Wire jumper between the Main board and the OLED screen pins for thouse points. This will eliminate the Pinheader. It should be related to the pinheader.
Poopenheimer:
I am now reading through other posts in general, and saw the noise reduction update. The kit I received also contains the metal plate, resistor and patch wire to make the alteration to the OLED connection. I'll do the fix when I get home today and also do the work around you recommended. Thank you for the response, hopefully it clears up!
shwanton:
I figured out the issue. I was missing the jumper that was required after adding the resistor for the screen noise issue. Now things are working great. Thanks again for the help.
shwanton:
So I'm still getting screen issues when midi notes are being sent.
When the menu button is pressed and rebooted the screen works fine.
https://youtu.be/nyK6ygRsNug
I'm running 2.7 overclocked (could this be the issue?)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version