PreenFM > preenfm2 and preenfm3

modulating the frequency of an OP/OSC in octaves?

(1/1)

SMF:
Hello,

I have a question regarding the modulation of the frequency of a modulator...

Is it possible to quantize the frequency of an oscillator/operator with preenFM2? That is: Say, you have an LFO and use this to slowly modulate the frequency of an oscillator. The result normally will be a smooth transition from factor 1.0 over 1.1 over ... to a factor of -- say -- 4.0. Is it possible to leave out the fractional parts? So, that wathever the LFO-Value is, the resulting frequency-ratio of the oscillator is strictly non-fractional? (It should ramp up and down in octaves... and BTW I chose an LFO in this explanaition but this is not my primary intention. I would like to use velocitly or the free-env as input-source for this...)

Many thanks,
Stefan

Xavier:

Not sure i fully understand but I don't think you can do that.

You can try to use step sequencer in the LFO. You will get jump in frequency.

Navigation

[0] Message Index