PreenFM > preenfm2 and preenfm3

PFM2 & Ableton

(1/2) > >>

Naive Teen Idol:
I know Preen is controlled by NRPN and Ableton doesn't "do" NRPNs, but is there any way to get Ableton to control the editor via VST/AU/etc.? I see that when I wiggle a knob (say, Algo) on the editor with the Device in "Configure" mode, Algo is recognized by the device. But then when I move the device parameter, the editor does nothing.

Is that just the way it is? I'm using a Novation Remote SL that I'd like to map some controls onto if possible ...

Xavier:

It should work, the plugin "talks" directly to the preenfm2 without abelton live at all.
Make sure the preenfm2 midi port is not enabled in ableton midi input/output and select it from inside the plugin.
Change the midi channel to match your settings.

In the preenfm2 settings you must have :
Send : NRPN.
Receive : NRPN and CC.
Thru : off

Naive Teen Idol:
I may not have been clear – I’m able to get the editor to talk to the Preen and Ableton (the device knows when I’m changing a parameter). What I’m not able to do is get Ableton to talk to the editor.

Is that doable?

Xavier:

--- Quote from: Naive Teen Idol on January 21, 2020, 02:38:33 AM ---I may not have been clear – I’m able to get the editor to talk to the Preen and Ableton (the device knows when I’m changing a parameter). What I’m not able to do is get Ableton to talk to the editor.

Is that doable?

--- End quote ---

I just tried and you're correct. Automation is not propagated from ableton to the preenfm2 plugin.  ???

Will take try to figure out what's wrong....

Xavier:
Ouch !!!!
Juce change :
https://forum.juce.com/t/we-are-removing-audioprocessor-based-parameter-management/26032/20
Editor code :
https://github.com/Ixox/preenfm2Controller/blob/master/Plugin/Source/PluginProcessor.cpp#L752


I upgraded the juce library version with 2.11.x version and they modified the way the plugin listen to parameter changes on host  :(
I'll fix this asap.

Navigation

[0] Message Index

[#] Next page