1
preenfm2 and preenfm3 / seems to work, but no display
« on: January 16, 2017, 02:57:43 AM »
I finally build my PreenFM2 kit from Van Daal, and it appears to work, but I have no display. The LEDs flash, and I get stereo sound from each of the 5 switches when I hold down the menu key. Both USB and 9v + work.
All the voltages check out from the image on http://ixox.fr/forum/index.php?topic=63509.0.
I do have one question. I have a 5c revision of the board in the kit from Van Daal. For the OLED resistor, should it be 22, 68, or just a short? The build documentation is a little confusing, as it says to use 22 in one place, and a resistor pin in another paragraph for the OLED screen, but the board is labeled 68.
I am pretty much a beginner solderer, but I'm fairly confident all my joints are solid.
All the voltages check out from the image on http://ixox.fr/forum/index.php?topic=63509.0.
I do have one question. I have a 5c revision of the board in the kit from Van Daal. For the OLED resistor, should it be 22, 68, or just a short? The build documentation is a little confusing, as it says to use 22 in one place, and a resistor pin in another paragraph for the OLED screen, but the board is labeled 68.
I am pretty much a beginner solderer, but I'm fairly confident all my joints are solid.