Show Posts
1
preenfm2 and preenfm3 / possibility of obtaining a new pcb? or schematic?
« on: April 07, 2017, 04:48:48 AM »
I totally borked my build of the preenFM2. I had soldered the 22uF and 220uF capacitors in backwards. I plugged it in, obviously didn't work. Double checked my work and re-installed them.
The second time I installed them in the wrong spots. Correct polarity but swapped the 22uF with the 220uF. I plugged it in to see if it would work... then double checked everything and realized my error.
Third times a charm right? Then upon removing them again the pads are gone, no where to solder into...
I'm wondering about a couple things.
1. Did I blow up any components?
2. Is there a schematic? i could possibly run jumpers...
3. What would it take to acquire a new pcb?
The second time I installed them in the wrong spots. Correct polarity but swapped the 22uF with the 220uF. I plugged it in to see if it would work... then double checked everything and realized my error.
Third times a charm right? Then upon removing them again the pads are gone, no where to solder into...
I'm wondering about a couple things.
1. Did I blow up any components?
2. Is there a schematic? i could possibly run jumpers...
3. What would it take to acquire a new pcb?