1
preenfm2 and preenfm3 / "proper" MPE support for preenfm3
« on: April 05, 2021, 11:26:13 AM »
it would be great to have more proper MPE support on preenfm3.
what would be needed?
an instrument can be set to MPE which would enable the following (ideally):
receives midi on selected channels (2-(x<=16).
receives pitchbend on those channels which affects only the notes that sounded on that channel. usually the pitchbend for this "note pitchbend" is set to 48 semitones, but 12 24 and 36 is also possible.
i think that is all.
this would greatly reduce the setup time for MPE instruments and would allow us MPE-peoples to use the limiter etc. properly.
what would be needed?
an instrument can be set to MPE which would enable the following (ideally):
receives midi on selected channels (2-(x<=16).
receives pitchbend on those channels which affects only the notes that sounded on that channel. usually the pitchbend for this "note pitchbend" is set to 48 semitones, but 12 24 and 36 is also possible.
i think that is all.
this would greatly reduce the setup time for MPE instruments and would allow us MPE-peoples to use the limiter etc. properly.