Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kirkwood

Pages: [1]
1
wicked. thank you so much Lokki! The pcb png is a big help. I will try manually jumping these pads, hopefully next week.

2
I totally borked my build of the preenFM2. I had soldered the 22uF and 220uF capacitors in backwards. I plugged it in, obviously didn't work. Double checked my work and re-installed them.

The second time I installed them in the wrong spots. Correct polarity but swapped the 22uF with the 220uF. I plugged it in to see if it would work... then double checked everything and realized my error.

Third times a charm right? Then upon removing them again the pads are gone, no where to solder into...

I'm wondering about a couple things.

1. Did I blow up any components?
2. Is there a schematic? i could possibly run jumpers...
3. What would it take to acquire a new pcb?

Pages: [1]