PreenFM > preenfm2 and preenfm3
PCB Only/BOM problem reports
Xavier:
It is OK.
I have a working PreenFM2 with switch encoders.
You'll have to bend the 2 switch pins and eventually cut them.
Xavier
martindunne:
hi again can i use encoders with 20 dents instead of 24, will it cause any problems
martindunne:
hello also i have somme 1n4004 diodes at home could i use one of these instead of the 1n4001 in the bom
Xavier:
20 dents encoders should work if it uses the same quadrature output table as :
http://www.bourns.com/data/global/pdfs/pec11r.pdf
What model do you have ?
1n4004 can replace 1n4001.
Xavier
martindunne:
hi these are the encoders on ebay
http://www.ebay.co.uk/itm/121195339728?var=420187086302&ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
any good?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version