Show Posts
1
preenfm2 and preenfm3 / Done!
« on: November 21, 2013, 01:31:04 AM »
I just finished building the kit.
It took about 4 hours to get everything done (including a few breaks), and didn't run into any major problems following the guide.
The few minor issues I had were having to solder the usb port in at a slight angle, otherwise I couldn't get my usb stick in properly,
and the knobs on the encoders required quite some force to go down all the way.
Now back to making noise with it.
It took about 4 hours to get everything done (including a few breaks), and didn't run into any major problems following the guide.
The few minor issues I had were having to solder the usb port in at a slight angle, otherwise I couldn't get my usb stick in properly,
and the knobs on the encoders required quite some force to go down all the way.
Now back to making noise with it.