Messages

1

preenfm2 and preenfm3 / Re: Done!

« on: November 21, 2013, 04:07:22 PM »

Soldering the USB port with the stick in it would only partially solve the problem, since half of it is caused by the legs of the encoder, which go in later.

On the subject of that cable, is it supposed to show up as anything on the host side when you plug the usb cable in ?

And halfway through writing this post I thought of putting the jumper on j3, and it does show up in dfu mode, so at least the wiring is good.

2

preenfm2 and preenfm3 / Done!

« on: November 21, 2013, 01:31:04 AM »

I just finished building the kit.
It took about 4 hours to get everything done (including a few breaks), and didn't run into any major problems following the guide.

The few minor issues I had were having to solder the usb port in at a slight angle, otherwise I couldn't get my usb stick in properly,
and the knobs on the encoders required quite some force to go down all the way.




Now back to making noise with it.