1
preenfm2 and preenfm3 / Re: possibility of obtaining a new pcb? or schematic?
« on: April 09, 2017, 07:05:28 PM »
wicked. thank you so much Lokki! The pcb png is a big help. I will try manually jumping these pads, hopefully next week.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
preenfm2 and preenfm3 / possibility of obtaining a new pcb? or schematic?
« on: April 07, 2017, 04:48:48 AM »
I totally borked my build of the preenFM2. I had soldered the 22uF and 220uF capacitors in backwards. I plugged it in, obviously didn't work. Double checked my work and re-installed them.
The second time I installed them in the wrong spots. Correct polarity but swapped the 22uF with the 220uF. I plugged it in to see if it would work... then double checked everything and realized my error.
Third times a charm right? Then upon removing them again the pads are gone, no where to solder into...
I'm wondering about a couple things.
1. Did I blow up any components?
2. Is there a schematic? i could possibly run jumpers...
3. What would it take to acquire a new pcb?
The second time I installed them in the wrong spots. Correct polarity but swapped the 22uF with the 220uF. I plugged it in to see if it would work... then double checked everything and realized my error.
Third times a charm right? Then upon removing them again the pads are gone, no where to solder into...
I'm wondering about a couple things.
1. Did I blow up any components?
2. Is there a schematic? i could possibly run jumpers...
3. What would it take to acquire a new pcb?
Pages: [1]