Messages

1

preenfm2 and preenfm3 / Re: Can't save to usb

« on: May 14, 2017, 12:19:44 AM »

Save-Syx-Send Patch = message "Done" appears.

If 1- Midi OX waiting for Sysex. Midi port set to PreenFm2. Nothing happens.
If 2-Midi OX waiting for Sysex. Midi port set to "anything on wich Preen is connected via DIN5".  Dump succesfully received.

If I repeatedly dump the single sysex patch, once in a while it shows in the input monitor.
It looks like corrupted message is received (like no status byte is received as nothing is shown in the monitor)

Problem occurs only via USB port when sysex is involved. With standard message (upon reception) USB port works just fine.
I tried with different buffer size with no success.

2

preenfm2 and preenfm3 / Can't save sysex to midi usb

« on: May 05, 2017, 10:09:06 AM »

I can't save via USB to MidiOx.
No problem with Din5.
Very unreliable via USB (sometimes it works, sometimes nothing shows in Midiox)
I have a several Midi Interfaces and no problem with them using Preen Din5 (2 Midi express and RayDat)

Win7
Firm 2.07

3

preenfm2 and preenfm3 / Re: USB is only good for power supply

« on: April 14, 2017, 04:27:43 AM »

Doh!

I thought it was only used to flash the bootloader....

4

preenfm2 and preenfm3 / Re: USB is only good for power supply

« on: April 13, 2017, 01:47:09 AM »

Yes it's on

5

preenfm2 and preenfm3 / USB is only good for power supply

« on: April 12, 2017, 07:16:25 AM »

Hi, my PreenFM2 doesn't show in any of 3 computers (win7 win10 and Linux Ubuntu) neither as Midi interface or as USB stick when it boots with button 1 pressed.
However it powers ON and works with USB power.
I built it and flashed its bootloader to v1.11 a few months ago with the mini-usb.

I've try with several USB Cable and USB-midi is turned on in system.
Running firmware 2.07.

Any clue?

6

preenfm2 and preenfm3 / Re: Vibrato with MOD wheel?

« on: December 10, 2016, 09:02:44 PM »

Good enough! 

7

preenfm2 and preenfm3 / [Resolved in 2.07] Vibrato with MOD wheel?

« on: December 10, 2016, 06:42:28 AM »

Did I miss something? I can't find a way to modulate the LFO's amplitude with the MOD Wheel so I can control the vibrato on my lead sound......
Firmware 2.06
Or is there a work around?
the mod matrix is quite good but I'm still looking for a controlable vibrato.