Messages

1

preenfm2 and preenfm3 / Re: reset to default, waveform .txt, arpgeggiator toggle?

« on: September 20, 2017, 09:40:15 PM »

In Edit Manual beginning of section, it says hold down Menu button while turning knob to reset knob's parameter to its default value. But this doesn't happen for me; is this function still available using some other procedure though?
---------------
fwiw pdf on Algorithms page link is bad, though its link is good in the Downloads page; where however the DX7 banks link is dead. Also at top of Edit Manual section picture and description refer to LFO button though this is now relabeled MODS, and it's referred to that way later in the page. Hope this helps

2

preenfm2 and preenfm3 / Re: arpgeggiator toggle, waveform .txt?

« on: September 16, 2017, 03:57:21 PM »

Thanks! Good references for waveform texts.

Got the Preen, excited especially about 8 voice polyphony with Scala scales!

Operator editing also looks novel and interesting.

3

preenfm2 and preenfm3 / reset to default, waveform .txt, arpgeggiator toggle?

« on: September 14, 2017, 11:01:11 PM »

Hi, I should have my preenfm2 in a couple days [now have] and have been going through the manual before receiving it. I have a couple questions and apologize for my level of ignorance.

Arpeggiator:  I'd like to be able to turn arp function on and off while playing.  so I wonder if there is an Arp. on/off toggle, or is it necessary to navigate to the Edit>Arp menu to turn Arp. on and off?

Less important, I'm unclear on waveforms which can be imported as .txt files, speciifically if there's a freeware converter in which I could draw or import curves which would be converted into the proper format files for import into preen? OK thx!