1
preenfm2 and preenfm3 / Re: reversed encoders problem
« on: February 03, 2019, 02:08:53 AM »
managed to set the device to the INVERTED ENCODERS setting the SPATULACITY way. thanks to you, as well!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
preenfm2 and preenfm3 / Re: reversed encoders problem
« on: February 03, 2019, 01:51:34 AM »
a feedback.
well, i have the same issue after flashing the 2.09a Firmware:
still only 2 encoder options. no inverse.
i might try itthe SPATULACITY way, but i am a bit concerned, because i have zero coding $KILL$.
well, i have the same issue after flashing the 2.09a Firmware:
still only 2 encoder options. no inverse.
i might try itthe SPATULACITY way, but i am a bit concerned, because i have zero coding $KILL$.
3
preenfm2 and preenfm3 / Re: reversed encoders problem
« on: January 30, 2019, 01:25:41 AM »
Thanks for your incredibly quick response and help.
You are awesome!
<3
You are awesome!
<3
4
preenfm2 and preenfm3 / reversed encoders problem
« on: January 27, 2019, 03:23:13 AM »
hi everybody and especially Xavier,
just finished the build of a new preenFM2 with a friend and we are happy that all (almost!) worked on the first try. thanks for this wonderful project.
now the question, as some people have had before (here: http://ixox.fr/forum/index.php?topic=2320.msg2781#msg2781), for this build we used cheap encoders, that are reacting in reverse direction (the value steps per click work fine). we thought we would find an easy fix as it seemed to be solved in the thread, but the special firmware link is dead now. also it was a fix for the BLUE one from 2012.
is there a new firmware fix for this to be found somewhere and how can that be embedded into the existing one, how does the update work?
any hints highly appreciated. thanks
here are the specs for the encoders we have used:
Position: 20
Puls: 20
2-Bit Gray-Code
Closed Circuit resistance: 3 Ohm Maxima
Max. : 10 mA at 5 VDC
just finished the build of a new preenFM2 with a friend and we are happy that all (almost!) worked on the first try. thanks for this wonderful project.
now the question, as some people have had before (here: http://ixox.fr/forum/index.php?topic=2320.msg2781#msg2781), for this build we used cheap encoders, that are reacting in reverse direction (the value steps per click work fine). we thought we would find an easy fix as it seemed to be solved in the thread, but the special firmware link is dead now. also it was a fix for the BLUE one from 2012.
is there a new firmware fix for this to be found somewhere and how can that be embedded into the existing one, how does the update work?
any hints highly appreciated. thanks
here are the specs for the encoders we have used:
Position: 20
Puls: 20
2-Bit Gray-Code
Closed Circuit resistance: 3 Ohm Maxima
Max. : 10 mA at 5 VDC
Pages: [1]