Topics

1

preenfm2 and preenfm3 / Adding a powerswitch

« on: July 11, 2014, 11:12:05 AM »

[Edited by Xavier: Split from another thread]
[Edited by Holyver: Copied some text from the original thread to make it clearer]

I wanted to include a powerswitch, and I found out that you can fit a small SPDT-toggle in the left side panel without drilling any extra holes. Just use the hole from the preen logo, and make sure to cut the legs from the tactile switches underneath it to avoid causing any short circuits by the body of the switch.

While taking the pictures, I remembered something else. The spacers for the display are a too short to get the display aligned with the top of the case, so i put small pieces of tubing I had lying around as extra spacers. But maybe the display is supposed to be tilted in the plexi case? Probably just a matter of personal preference anyway.
For the wiring, the indicated length for the MIDI-socket-wires seemed a bit short (especially the shorter one, i think), which caused the cables to come off the pins on the PCB's. I think 1 cm extra would be safer.

(To be clear: these remarks are really not meant to whine, but are intended as little tips for future builders)

2

preenfm2 and preenfm3 / [SOLVED] Fresh PreenFM2, but with display problem

« on: July 02, 2014, 12:29:41 AM »

Hi,

A couple of days ago I built the PreenFM2, which I'm pretty exited about. I want to thank Xavier for the great work!

However, there's a problem with the display. Between the third and the fourth line, there are pixels lighting up which shouldn't be lit. I hope you can see it in the pictures. The pixels only light up when there's text on the third and/or fourth line, and which pixels light up depends on what is showing in these lines. Luckily, the synth works perfectly besides that.
I've already reflown al solder joints for the display connection, both on the display board and the main board, but that didn't help. Does anyone have any idea about what I could check to cure this problem?

Thanks in advance!