16
preenfm2 and preenfm3 / Re: Built! (but with only one output working :/)
« on: June 07, 2014, 09:28:32 PM »
Both issues sorted- encoder resolution thing solved that problem and found a joint I missed... hurrah indeed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1 [2]
17
preenfm2 and preenfm3 / Re: Built! (but with only one output working :/)
« on: June 07, 2014, 07:25:52 PM »
Yeah they were from the kit- Ill have a look into that setting when testing later, thanks!
18
preenfm2 and preenfm3 / Built!
« on: June 07, 2014, 05:48:50 PM »
Picked up from the post office this morning, a few hours later and Im done...
Beauty, I knew those old elektron knobs would come in handy on something!
Anyway, I think I have an issue with one of my outputs- from what I can tell only one of them is working. I'll have a proper poke around in a bit but if anyone has any ideas Im all ears- plan is to test again and start by checking the soldering on the output. Also is it normal that the encoder clicks represent two turns? To make a fine change I have to go really slow to avoid skipping on another value.*FIXED*
Beauty, I knew those old elektron knobs would come in handy on something!
Anyway, I think I have an issue with one of my outputs- from what I can tell only one of them is working. I'll have a proper poke around in a bit but if anyone has any ideas Im all ears- plan is to test again and start by checking the soldering on the output. Also is it normal that the encoder clicks represent two turns? To make a fine change I have to go really slow to avoid skipping on another value.*FIXED*
Pages: 1 [2]