Messages

1

preenfm2 and preenfm3 / Re: PreenFM Eurorack module

« on: April 19, 2019, 08:55:06 AM »

Hello CometBoogers,
I had the same problem. Ardi Mäesalu from Van Daal Electronics had sent me this picture. The circle is the ring on the diode.

Greetings Klaus

2

preenfm2 and preenfm3 / Re: PreenFM Eurorack module

« on: April 18, 2019, 08:15:10 PM »

Very odd.

I just downloaded the file again and installed it: and behold, everything is fine. Somebody should understand that.
Now all I have to do is figure out how to get a preset of a sound by turning it on.

Greetings Klaus

3

preenfm2 and preenfm3 / Re: PreenFM Eurorack module

« on: April 16, 2019, 07:43:10 PM »

The firmware version P2_209AO.BIN cannot be used with the rebuild,
the modification is not implemented.
Version P2_209A.BIN has this implementation.

Really ? 
I cannot check this week as i'm far from home.
Can be a mistake when building the zip file.

Really(I think so).
My be after Eastern you can fix it.
Klaus

4

preenfm2 and preenfm3 / Re: PreenFM Eurorack module

« on: April 16, 2019, 12:43:13 AM »

What is your disapointment about?

You need to poulate the boards and wire it together and your are ready to go.
I will answer all your questions by email.

Firmware is available on PreenFM Github.
https://github.com/Ixox/preenfm2/releases
Get this file: pfm2_Eurorack_2.09a.zip


The modification has been done by many users.

Ok,
have build it.
The firmware version P2_209AO.BIN cannot be used with the rebuild,
the modification is not implemented.
Version P2_209A.BIN has this implementation. So you can't use the overclocked version.
Otherwise the rebuild worked and it would be nice if the version P2_209AO.BIN is supplemented with the CV.
Hope that I'm right.

Greetings
Klaus

5

preenfm2 and preenfm3 / Re: PreenFM Eurorack module

« on: April 03, 2019, 12:04:18 PM »

What is your disapointment about?

You need to poulate the boards and wire it together and your are ready to go.
I will answer all your questions by email.

Firmware is available on PreenFM Github.
https://github.com/Ixox/preenfm2/releases
Get this file: pfm2_Eurorack_2.09a.zip


The modification has been done by many users.

ok, thanks for your information. I will try to do it.
Klaus

6

preenfm2 and preenfm3 / Re: PreenFM Eurorack module

« on: April 02, 2019, 08:14:56 PM »

Hello,
I have now also bought the conversion kit and am still very disappointed.
I have the following questions:
Which software version is needed and where can I get it?
Is there a reasonable construction manual for the modification?
What about the IC3 7805? Do I have to solder it in?
Where is the circuit diagram?

I'm really in doubt whether I'm going to do the modification.
The information is nevertheless very daring.
Has a user of the Preem already done the modification?

Greetings Klaus