PreenFM > preenfm2 and preenfm3
pfm2 : 2.21
vurt:
In the filter section, would it be possible to add a mixer which just makes the audio louder (like x2 or even x3)? I like it when i can make all patches in around the same volume. It's possible to do that, but then i have to turn down the volume down to perhaps half on most patches, and then full volume on the few patches that gets really quiet (maybe they have more than 1 voice or use waveforms which isn't as loud as some, then they get very quiet).
I find that many of the filters will also make the volume go down a ton, which often makes me not want to use them at all since the overall volume will just be too low. It often also seems to kill the low end completely. I often use just 1 voice which gets the volume up for the patch, when using several voices the volume is lowered by perhaps 50% for some reason.
The "Bass" filter is the one filter which is most useful i think, it does seem to make the volume go up by perhaps 15% or so, so its somewhat useful for that (and some patches does sound good with more bass too). I also get the feeling that the filter reacts as if the signal is going in to the filter is bit too hot, at least it's how it can sometimes sound (i obviously don't know how this really works in software).
Xavier:
--- Quote from: vurt on February 02, 2021, 10:08:34 AM ---In the filter section, would it be possible to add a mixer which just makes the audio louder (like x2 or even x3)?
--- End quote ---
There's a gain in all filters. The gain is applied before the filter, so you can lower it if the filter saturates.
It's often the case with LP and high resonnance.
The gain goes up to 2.0 (2x).
It's difficult to use high filter gain when you have a filter selected, but for the 2 first choices (None and Mix) it should be OK.
yes, a Mix section is lacking in the pfm2.
vurt:
ok, good to know!
superfake:
Hi Xavier!
Hmm ... While collecting patches in the bank, I discovered a strange thing ...
The patches that were created on the old firmware from Toltekradiation using filters and effects such as LPx1/2, TXR1/2, ROT and others are loaded and use these filters, although they are not in firmware 2.20. Moreover, you can switch the types of effects, where all the old effects will be and they work. :o But once you reach the last filter on the list, all old filters disappear.
That is, in firmware 2.20, all these filters are present, but hidden?
Is it possible to make them always active? All of them could give quite interesting colors in sound design.
Otherwise, I'm in some confusion while collecting the bank ... is it worth leaving the old effects in presets? ::)
Xavier:
--- Quote from: superfake on February 12, 2021, 05:11:09 PM ---That is, in firmware 2.20, all these filters are present, but hidden?
Is it possible to make them always active? All of them could give quite interesting colors in sound design.
Otherwise, I'm in some confusion while collecting the bank ... is it worth leaving the old effects in presets? ::)
--- End quote ---
That's exactly how it works.
They are present bug hidden.
In addition some of them may have a different position in the list, so the filter can be different in Toltekradiation firmware and in 2.20.
They are available from the Editor also.
I'm ready to spend a little time to have some new banks :)
So let me know if you need help. I can have a look and adapt locally the editor to convert the filter numbers if you have problems.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version