I noticed that some FM synths allow detuning in cents and Hz. I originally assumed that it was just to allow finer degrees of detuning, but now I understand more about synthesis and sound in general I realise the purpose
Hz is of course a linear measurement whereas cents are a (very small) musical interval. So a detune in Hz is actually a different interval depending on what note you're playing. "How could that be useful!?" I hear you think. Well anyone who is familiar with detune by cents on a digital (therefore stable) synth may have noticed that the beat frequency is proportional to the note you're playing. A note an octave higher will beat twice as fast.
The beat frequency is the difference in Hz between the two oscillators, so the beating is changing frequency because when you play an octave higher you've doubled the frequency of both oscillators, so the difference between their frequencies has also doubled - doubling the rate of beating.
If you detune by a fixed number in Hz then you get the same beating rate on every note. This is particularly useful in FM where detune between modulators and carriers causes timbral changes and note just a 'chorusing' sound.
This isn't a feature request, just some thoughts.
I would propose it as a third "FTyp" parameter, maybe called KeHz or something. Freq would still be a ratio setting on this mode, but Ftun would be in Hz instead of cents. This would allow for sounds that have a cycling quality that is at a consistent rate across the keyboard. I think 2 decimal places (allowing for 0.01) is good as it allows incredibly slow phasing.
