PreenFM > preenfm2 and preenfm3

"proper" MPE support for preenfm3

<< < (7/7)

Xavier:

--- Quote from: lokki on April 17, 2021, 09:48:40 PM ---a thought on unison.
for the near future, if voices of a patch (MPE or regular poly) is smaller then the max voice count of preenfm3 (by a factor of at least two) you could add one unison voice theoretically, no?
so for example:
a 4 voice MPE synth sound could have 4*4 voices (4 unison voices per voice) to get the maximum of 16 voices.
-unison voices don't need their own fx path, they could be added together before any filter/fx. maybe that could boost the voice count a little?
a second idea is to have a unison "fake" module. i had pretty good results with a small delay line (around 50ms) and a couple of read-heads that simply start in different positions of the delay-buffer. if you then also modulate the read-speed a little you can get pretty good results (chorus)

--- End quote ---

All this is for sure doable. (except delay that likely requires more RAM that the pfm3 have).
But I don't think i'll spend time on that in the near future.

served:
Hi.

What would be the cheapest hardware controllor for PreenFM with MPE support?
I have seen the USB versions a lot. But not with DIN5 midi out.
Any suggestions?

lokki:
Define cheap. For about 1000 Euro or a little less you can get a Linnstrument 128 which has din-midi

The qunexus keyboards (keith mc millen) have din midi (via adapter) and a kind of MPE mode, no pitchshifting/sliding from one to the other key, but pressure and position sensors. Those are much cheaper (around 150 i guess)

But it should be easy enough to program an arduino with an usb host shield (or a teensy) to send usb-midi to serial midi output....

Navigation

[0] Message Index

[*] Previous page