Owing only to my carelessness, I broke the acrylic side panel on my PFM2, which gave an opportunity to do a little bit of customization.
The Tinkercad design below should work right off of the print bed, although it is not perfect. There are little artifacts that could be smoothed over by the experienced 3D artist if they so wish, but you need to be looking very closely to see most of them. I'm happy with how it turned out!
This is printed with wood infused PLA+, which was coarsely sanded and stained using alcohol ink markers with a finish of matte medium. Others have used proper wood stain and clear coat with just as good or better result. I just happen to have a ton of art supplies lying around.
Please note that this requires the PreenFM2 R6 with the acrylic bottom and back panel.
https://www.tinkercad.com/things/fXG2X080Rk4
